Chapter 6 WAN
LTE3301 Series User’s Guide
57
6.6 IPv6
Use this screen to configure the LTE3301’s IPv6 settings. Click
Ne two rk
>
WAN > IPv6
from the
C o nfig ura tio n
menu.
Fig ure 32
Network > WAN > IPv6
The following table describes the labels in this screen.
Table 16 Network > WAN > IPv6
LABEL
DESC RIPTIO N
IPv6
Select
Ena b le
to allow the LTE3301 to run IPv6. Otherwise, select
Disa b le
.
IPv6 Connection
Select
Sta tic IPv6
if you have a fixed IPv6 address assigned by your ISP.
Select
DHC Pv6
if you want to obtain an IPv6 address from a DHCPv6 server.
Select
PPPo E
if your ISP requires your to use a PPPoE connection to the IPv6 Internet. This
method of connection typically requires you to enter a Username and Password
(provided by your ISP) to gain access to the IPv6 Internet. You need to ensure that any
PPPoE client software on your computer is removed or disabled.
Select
6RD
to enable IPv6 rapid deployment to tunnel IPv6 traffic from the local network
through the ISP’s IPv4 network
(These fields appear when the
IPv6 C o nne c tio n
is set to
Sta tic IPv6
.)
IPv6 Address
Enter the IPv6 address on the WAN side in this field.
Subnet Prefix Length
Enter the address prefix length to specify how many most significant bits in an IPv6
address compose the network address.
Default Gateway
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the
same segment as your LTE3301's interface(s). The gateway helps forward packets to their
destinations.
Primary DNS Address
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary DNS
Address
Enter the second IPv6 DNS server address assigned by the ISP.
