Chapter 14 Bandwidth Control
XMG1930 Series User’s Guide
163
The following table describes the related labels in this screen.
Table 72 Advanced Application > Bandwidth Control
LABEL
DESCRIPTION
Active
Select this check box to enable bandwidth control on the Switch.
Port
This field displays the port number.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active
Select this check box to activate ingress rate limits on this port.
Ingress Rate
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming traffic flow
on a port.
Note: Ingress rate bandwidth control applies to layer 2 traffic only.
Active
Select this check box to activate egress rate limits on this port.
Egress Rate
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-going traffic
flow on a port.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the
Save
link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to reset the fields.
