Chapter 6 Tutorials
XMG1930 Series User’s Guide
80
Figure 54
Tutorial: Add Tag for Frames Received on Port 2
11
Click the
Save
link in the upper right of the Web Configurator to save your configuration permanently.
6.2.3 Configure DHCPv4 Relay
Follow the steps below to enable DHCP relay on the Switch and allow the Switch to add relay agent
information (such as the VLAN ID) to DHCP requests.
1
Click
IP Application
>
DHCP
>
DHCPv4
and then the
Global
link to open the
DHCP Relay
screen.
2
Select the
Active
check box.
3
Enter the DHCP server’s IP address (192.168.2.3 in this example) in the
Remote DHCP Server 1
field.
4
Select
default1
or
default2
in the
Option 82 Profile
field.
5
Click
Apply
to save your changes back to the run-time memory.
Figure 55
Tutorial: Set DHCP Server and Relay Information
6
Click the
Save
link in the upper right of the Web Configurator to save your configuration permanently.
7
The DHCP server can then assign a specific IP address based on the DHCP request.
6.2.4 Troubleshooting
Check client
A
’s IP address. If it did not receive the IP address 172.16.1.18, make sure:
