Chapter 7 Management
MGS3750-28F User’s Guide
69
Figure 57
Syslog Setup Screen
The following table describes the fields in this screen.
7.4.1 Syslog Server Setup
Figure 58
Syslog Server Setup Screen
The following table describes the fields in this screen.
Table 50
Syslog Setup Screen
LABEL
DESCRIPTION
Active
Select the check box at the top to enable syslog, and deselect to disable this function.
Logging type
Select the "active" check box to enable the server's logging function.
Active
Select this option to set the device to generate logs for the corresponding category.
Facility
The default Facility is local use 7. Click to select other syslog server functions from the
pull-down menu.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 51
Syslog Server Setup Screen
LABEL
DESCRIPTION
Active
Select this check box to have the Switch send logs to this syslog server. Clear the
check box if you want to create a syslog server entry but not have the Switch send
logs to it (you can edit the entry later).
Server Address
Enter the IP address of the syslog server.
Log Level
Select the severity level(s) of the logs that you want the Switch to send to this syslog
server. The lower the number, the more critical the logs are.
Add
Click
Add
to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power.
