Chapter 4 WAN
PMG5318-B20B User’s Guide
25
4.2.1.3 WAN IP Address and DNS Server
The screen differs by the encapsulation you selected in the previous screen.
PPPoE
This screen displays when you select
PPP over Ethernet (PPPoE)
in the
WAN Service
Configuration
screen.
Table 13
WAN Service: WAN Service Configuration
LABEL
DESCRIPTION
Select WAN service
type
Select the method of encapsulation used by your ISP.
Choices are
PPP over Ethernet (PPPoE)
,
IP over Ethernet
and
Bridging
.
Allow as IGMP
Multicast Source
This displays when you select the
Bridging
service type. Select this to have
the GPON Device add routing table entries based on the IGMP traffic.
Allow as MLD
Multicast Source
This displays when you select the
Bridging
service type. Select this to have
the GPON Device add routing table entries based on the MLD traffic.
Enter Service
Description
Specify a name to identify the service.
veip0
stands for a virtual Ethernet card and is the foundation for veip0/*
which are virtual WAN interfaces of the physical GPON line.
eth0
~
eth3
represent the ethernet LAN ports 1 ~ 4.
Enter 802.1P
Priority [0-7]
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a
MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this
connection. The greater the number, the higher the priority level.
You can configure this field after the OLT provisions a valid data path model
through OMCI (ONT Management Control Interface).
Enter 802.1Q VLAN
ID [0-4094]
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
You can configure this field after the OLT provisions a valid data path model
through OMCI (ONT Management Control Interface).
Select VLAN TPID
Select a Tag Protocol Identifier (TPID) the GPON Device to add it to the
service’s packets.
Network Protocol
Selection
Select
IPv4 Only
to have the GPON Device use only IPv4.
Select
IPv4&IPv6(Dual Stack)
to let the GPON Device connect to IPv4 and
IPv6 networks an choose the protocol for applications according to the address
type. This lets the GPON Device use an IPv6 address when sending traffic
through this connection. You can only select this for a WAN service that uses
the PPPoE or IPoE encapsulation method over the layer 2 interface.
Select
IPv6 Only
to have the GPON Device use only IPv6.
Back
Click this button to return to the previous screen.
Next
Click this button to continue.
