Chapter 7 Security
PMG5318-B20B User’s Guide
52
7.3 MAC Filtering Setup
Click
Advanced Setup > Security > MAC Filtering
to display the following screen. This screen
displays a list of the configured MAC address filtering rules.
MAC Filtering
Table 33
MAC Filtering
LABEL
DESCRIPTION
MAC Filtering Policy
For Each Interface
Interface
This displays the interface to which this rule is applied.
Policy
This displays the MAC filtering policy for each WAN interface in bridge mode on the
GPON Device. By default, the GPON Device allows all frames to pass through the bridge
connection.
Change
Select the check box next to the interface for which you want to change the MAC
filtering policy.
Change Policy
Select the
Change
check box and click
Change Policy
to have the GPON Device
change to block or allow all frames on this interface.
Interface
This displays the WAN interface(s) to which this rule is applied.
Protocol
This displays the IP protocol (
PPPoE
,
IPv4
,
IPv6, AppleTalk
,
IPX
,
NETBEUI
or
IGMP
) to which this rule applies.
Destination MAC
This displays the destination MAC address to which this rule applies.
Source MAC
This displays the source MAC address to which this rule applies.
Frame Direction
This indicates the traffic direction in which the filtering occurs (
LAN <=> WAN
,
LAN
=> WAN
,
WAN => LAN
).
Remove
Select the rule(s) you want to delete in the
Remove
column and then click the
Remove
button.
Add
Click
Add
to create a new rule.
Remove
Click
Remove
to delete the selected rule(s).
