Prestige 642R Series ADSL Router
Remote Node TCP/IP Configuration
5-3
Figure 5-3
Menu 11.3 for LLC-based Multiplexing
In this case, only one set of VPI and VCI numbers need be specified for all protocols. The valid range for
the VPI is 0 to 255 and for the VCI is 32 to 65535 (1 to 31 is reserved for local management of ATM
traffic).
The following diagram explains the sample IP addresses to help you understand the field of
My Wan
Addr
in
Menu 11.3
. Refer to the following figure for a brief review of what a WAN IP is.
My WAN Addr
indicates the local Prestige WAN IP while
Rem IP Addr
indicates the peer WAN IP.
Menu 11.3 - Remote Node Network Layer Options
VPI/VCI (LLC-mux or PPP/PPPoE Encap):
VPI #= 0
VCI #= 35
IP Options :
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
IPX Options:
Rem LAN Net #= N/A
My WAN Net #= N/A
Hop Count= N/A
Tick Count= N/A
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Dial-On-Query= N/A
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CANCEL:
Only one set of
VPI and VCI
numbers need
be specified as
for
LLC-based
multiplexing or
when using
PPP
or
PPPoE
encapsulation.
One VC may
carry different
protocols.
Summary of Contents for Prestige 642R Series
