Chapter 1 Power Module Installation
Power Module Hardware Installation Guide
5
1.1.2 Removing a Power Module
Use the following procedure to remove a power module from the Switch.
1
Disconnect the power before you begin.
2
Use a screwdriver to loosen the screws on the front panel of the power module.
3
Grab the handle and slide the power module out.
4
Use a screwdriver and screws to put the power slot cover back.
1.1.3 Power Module LEDs
The following table describes the power module LED.
Table 1
Power Module LEDs
LED
COLOR STATUS
DESCRIPTION
AC OK
Green
On
The module is functioning normally.
Off
The power is off or the module is not ready or malfunctioning.
