Chapter 9 Wireless
UAG Series User’s Guide
138
Each field is described in the following table.
Table 54
Configuration > Wireless > AP Management
LABEL
DESCRIPTION
Edit
Select an AP and click this button to edit its properties.
Remove
Select one or multiple APs and click this button to remove the AP(s) from the list.
Note: If in the
Configuration > Wireless > Controller
screen you set the
Registration
Type
to
Always Accept
, then as soon as you remove an AP from this list it
reconnects.
Reboot
Select one or multiple APs and click this button to force the AP(s) to restart.
LED On
Select an AP and click this button to disable the AP’s LED suppression mode. The AP
LEDs stay lit after the AP is ready. This button is not available if the selected AP doesn’t
support suppression mode.
LED Off
Select an AP and click this button to enable the AP’s LED suppression mode. All the
LEDs of the AP will turn off after the AP is ready. This button is not available if the
selected AP doesn’t support suppression mode.
#
This field is a sequential value, and it is not associated with any entry.
IP Address
This field displays the IP address of the AP.
MAC Address
This field displays the MAC address of the AP.
Model
This field displays the AP’s hardware model information. It displays
N/A
(not
applicable) only when the AP disconnects from the UAG and the information is
unavailable as a result.
R1 Mode / Profile
This field displays the operating mode (
AP
) and AP profile name for Radio 1. It displays
n/a
for the profile for a radio not using an AP profile.
R2 Mode / Profile
This field displays the operating mode (
AP
) and AP profile name for Radio 2. It displays
n/a
for the profile for a radio not using an AP profile.
Mgnt. VLAN ID(AC)
This displays the Access Controller (the UAG) management VLAN ID setting for the AP.
Mgnt. VLAN ID(AP)
This displays the runtime management VLAN ID setting on the AP.
VLAN Conflict
displays if the AP’s management VLAN ID does not match the
Mgnt. VLAN ID(AC)
.
This field displays
n/a
if the UAG cannot get VLAN information from the AP.
Description
This field displays the AP’s description, which you can configure by selecting the AP’s
entry and clicking the
Edit
button.
