Chapter 46 System
UAG Series User’s Guide
530
46.12.1 Add/Edit Trusted RADIUS Client
Click
Configuration > System > Auth. Server
to display the
Auth. Server
screen. Click the
Add
icon or an
Edit
icon to display the following screen. Use this screen to create a new entry or edit an
existing one.
Figure 371
Configuration > System > Auth. Server > Add/Edit
The following table describes the labels in this screen.
Table 250
Configuration > System > Auth. Server > Add/Edit
LABEL
DESCRIPTION
Activate
Select this check box to make this profile active.
Profile Name
Enter a descriptive name (up to 31 alphanumerical characters) for identification purposes.
IP Address
Enter the IP address of the RADIUS client that is allowed to exchange messages with the
UAG.
Netmask
Enter the subnet mask of the RADIUS client.
Secret
Enter a password (up to 64 alphanumeric characters) as the key to be shared between the
UAG and the RADIUS client.
The key is not sent over the network. This key must be the same on the external
authentication server and the UAG.
Description
Enter the description of each server, if any. You can use up to 60 printable ASCII
characters.
OK
Click
OK
to save the changes.
Cancel Click
Cancel
to discard the changes.
