Chapter 5 Quick Setup Wizards
UAG Series User’s Guide
66
Otherwise, choose
PPPoE
or
PPTP
for a dial-up connection according to the information from your
ISP.
Figure 41
WAN Interface Setup: Step 2
The screens vary depending on what encapsulation type you use. Refer to information provided by
your ISP to know what to enter in each field. Leave a field blank if you don’t have that information.
Note: Enter the Internet access information exactly as your ISP gave it to you.
5.2.3 Configure WAN IP Settings
Use this screen to select whether the interface should use a fixed or dynamic IP address.
Figure 42
WAN Interface Setup: Step 2
•
WAN Interface
: This is the interface you are configuring for Internet access.
•
Zone
: This is the security zone to which this interface and Internet connection belong.
•
IP Address Assignment
: Select
Auto
If your ISP did not assign you a fixed IP address.
Select
Static
if you have a fixed IP address.
5.2.4 ISP and WAN Connection Settings
Use this screen to configure the ISP and WAN interface settings. This screen is read-only if you
select
Ethernet
and set the
IP Address Assignment
to
Auto
. If you set the
IP Address
