Chapter 46 System
UAG Series User’s Guide
492
To get the UAG date and time from a time server
1
Click
System > Date/Time
.
2
Select
Get from Time Server
under
Time and Date Setup
.
3
Under
Time Zone Setup
, select your
Time Zone
from the list.
4
As an option you can select the
Enable Daylight Saving
check box to adjust the UAG clock for
daylight savings.
5
Under
Time and Date Setup
,
enter a
Time Server Address
6
Click
Apply
.
46.5 Console Port Speed
This section shows you how to set the console port speed when you connect to the UAG via the
console port using a terminal emulation program. See
for default console port
settings.
Click
Configuration > System
> Console Speed
to open the
Console Speed
screen.
Figure 331
Configuration > System > Console Speed
The following table describes the labels in this screen.
Table 234
Configuration > System > Console Speed
LABEL
DESCRIPTION
Console Port Speed Use the drop-down list box to change the speed of the console port. Your UAG supports
9600, 19200, 38400, 57600, and 115200 bps (default) for the console port.
The
Console Port Speed
applies to a console port connection using terminal emulation
software and NOT the
Console
in the UAG Web Configurator
Status
screen.
Apply
Click
Apply
to save your changes back to the UAG.
Reset
Click
Reset
to return the screen to its last-saved settings.
