Chapter 21 IP/MAC Binding
UAG4100 User’s Guide
209
Interfaces Used With IP/MAC Binding
IP/MAC address bindings are grouped by interface. You can use IP/MAC binding with Ethernet,
bridge, VLAN interfaces. You can also enable or disable IP/MAC binding and logging in an interface’s
configuration screen.
21.2 IP/MAC Binding Summary
Click
Configuration > Network > IP/MAC Binding
to open the
IP/MAC Binding Summary
screen. This screen lists the total number of IP to MAC address bindings for devices connected to
each supported interface.
Figure 135
Configuration > Network > IP/MAC Binding > Summary
The following table describes the labels in this screen.
21.2.1 IP/MAC Binding Edit
Click
Configuration > Network > IP/MAC Binding > Edit
to open the
IP/MAC Binding Edit
screen. Use this screen to configure an interface’s IP to MAC address binding settings.
Table 93
Configuration > Network > IP/MAC Binding > Summary
LABEL
DESCRIPTION
Edit
Double-click an entry or select it and click
Edit
to open a screen where you can modify the
entry’s settings.
Activate
To turn on an entry, select it and click
Activate
.
Inactivate
To turn off an entry, select it and click
Inactivate
.
#
This field is a sequential value, and it is not associated with a specific entry.
Status
This icon is lit when the entry is active and dimmed when the entry is inactive.
Interface
This is the name of an interface that supports IP/MAC binding.
Number of
Binding
This field displays the interface’s total number of IP/MAC bindings and IP addresses that the
interface has assigned by DHCP.
Apply
Click
Apply
to
save your changes back to the UAG.