Chapter 25 Firewall
UAG4100 User’s Guide
244
Figure 166
Configuration > Firewall > Add
The following table describes the labels in this screen.
Table 109
Configuration > Firewall > Add
LABEL
DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen.
Enable
Select this check box to activate the firewall rule.
From
To
For through-UAG rules, select the direction of travel of packets to which the rule applies.
any
means all interfaces.
Device
means packets destined for the UAG itself.
Description
Enter a descriptive name of up to 60 printable ASCII characters for the firewall rule. Spaces
are allowed.
Schedule
Select a schedule that defines when the rule applies. Otherwise, select
none
and the rule is
always effective.
User
This field is not available when you are configuring a to-UAG rule.
Select a user name or user group to which to apply the rule. The firewall rule is activated
only when the specified user logs into the system and the rule will be disabled when the user
logs out.
Otherwise, select
any
and there is no need for user logging.
Note: If you specified a source IP address (group) instead of
any
in the field below, the user’s
IP address should be within the IP address range.
Source
Select an IPv4 address or address group to apply an IPv4 rule to traffic coming from it.
Select
any
to apply an IPv4 rule to all traffic coming from IPv4 addresses.
Destination
Select an IPv4 address or address group to apply an IPv4 rule to traffic going to it. Select
any
to apply an IPv4 rule to all traffic going to IPv4 addresses.
Service
Select a service or service group from the drop-down list box.
