Chapter 1 Introduction
UAG4100 User’s Guide
23
Object Reference
Click
Object Reference
to open the
Object Reference
screen. Select the type of object and the
individual object and click
Refresh
to show which configuration settings reference the object.
Figure 6
Object Reference
The fields vary with the type of object. The following table describes labels that can appear in this
screen.
CLI Messages
Click
CLI
to look at the CLI commands sent by the Web Configurator. Open the pop-up window and
then click some menus in the web configurator to dislay the corresponding commands.
Table 4
Object References
LABEL
DESCRIPTION
Object Name
This identifies the object for which the configuration settings that use it are displayed. Click
the object’s name to display the object’s configuration screen in the main window.
#
This field is a sequential value, and it is not associated with any entry.
Service
This is the type of setting that references the selected object. Click a service’s name to
display the service’s configuration screen in the main window.
Priority
If it is applicable, this field lists the referencing configuration item’s position in its list,
otherwise
N/A
displays.
Name
This field identifies the configuration item that references the object.
Description
If the referencing configuration item has a description configured, it displays here.
Refresh
Click this to update the information in this screen.
Cancel
Click
Cancel
to close the screen.
