Chapter 40 System
UAG4100 User’s Guide
379
40.7.5 Service Control Rules
Click
Add
or
Edit
in the
Service Control
table in a
WWW
,
SSH
,
Telnet
,
FTP
or
SNMP
screen to
add a service control rule.
Figure 253
Configuration > System > Service Control Rule > Edit
Edit
Double-click an entry or select it and click
Edit
to be able to modify the entry’s
settings.
Remove
To remove an entry, select it and click
Remove
. The UAG confirms you want to
remove it before doing so. Note that subsequent entries move up by one when you
take this action.
Move
To change an entry’s position in the numbered list, select the method and click
Move
to display a field to type a number for where you want to put it and press [ENTER] to
move the rule to the number that you typed.
#
This is the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the UAG’s (non-configurable)
default policy. The UAG applies this to traffic that does not match any other configured
rule. It is not an editable rule. To apply other behavior, configure a rule that traffic will
match so the UAG will not have to use the default policy.
Zone
This is the zone on the UAG the user is allowed or denied to access.
Address
This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
Action
This displays whether the computer with the IP address specified above can access the
UAG zone(s) configured in the
Zone
field (
Accept
) or not (
Deny
).
Authentication
Client Authentication
Method
Select a method the HTTPS or HTTP server uses to authenticate a client.
You must have configured the authentication methods in the
Auth. method
screen.
Apply
Click
Apply
to save your changes back to the UAG.
Reset
Click
Reset
to return the screen to its last-saved settings.
Table 187
Configuration > System > WWW > Service Control (continued)
LABEL
DESCRIPTION
