Chapter 22 Layer 2 Isolation
UAG5100 User’s Guide
220
22.2 Layer-2 Isolation General Screen
This screen allows you to enable Layer-2 isolation on the UAG and specific internal interface(s). To
access this screen click Configuration > Network > Layer 2 Isolation.
Figure 146
Configuration > Network > Layer 2 Isolation
The following table describes the labels in this screen.
22.3 White List
IP addresses that are not listed in the white list are blocked from communicating with other devices
in the layer-2-isolation-enabled internal interface(s) except for broadcast packets.
To access this screen click Configuration > Network > Layer 2 Isolation > White List.
Table 98
Configuration > Network > Layer 2 Isolation
LABEL
DESCRIPTION
Enable Layer2
Isolation
Select this option to turn on the layer-2 isolation feature on the UAG.
Note: You can enable this feature only when the firewall is enabled.
Member List
The Available list displays the name(s) of the internal interface(s) on which you can
enable layer-2 isolation.
To enable layer-2 isolation on an interface, you can double-click a single entry to move it or
use the [Shift] or [Ctrl] key to select multiple entries and click the right arrow button to
add to the Member list. To remove an interface, select the name(s) in the Member list
and click the left arrow button.
Apply
Click Apply to save your changes back to the UAG.
Reset
Click Reset to return the screen to its last-saved settings.