Chapter 25 Firewall
UAG5100 User’s Guide
251
25.2.2 The Firewall Add/Edit Screen
In the Firewall screen, click the Add icon or select an entry and click the Edit icon to display the
Add/Edit Firewall Rule screen.
Figure 172
Configuration > Firewall > Add/Edit
The following table describes the labels in this screen.
Table 110
Configuration > Firewall > Add/Edit
LABEL
DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen.
Enable
Select this check box to activate the firewall rule.
From
To
For through-UAG rules, select the direction of travel of packets to which the rule applies.
any means all interfaces.
Device means packets destined for the UAG itself.
Description
Enter a descriptive name of up to 60 printable ASCII characters for the firewall rule. Spaces
are allowed.
Schedule
Select a schedule that defines when the rule applies. Otherwise, select none and the rule is
always effective.
User
This field is not available when you are configuring a to-UAG rule.
Select a user name or user group to which to apply the rule. The firewall rule is activated
only when the specified user logs into the system and the rule will be disabled when the user
logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified a source IP address (group) instead of
any
in the field below, the user’s
IP address should be within the IP address range.
Source
Select an IPv4 address or address group to apply an IPv4 rule to traffic coming from it.
Select any to apply an IPv4 rule to all traffic coming from IPv4 addresses.