Chapter 1 Introduction
UAG5100 User’s Guide
26
Registration
Registration
Register the device and activate trial services.
Service
View the licensed service status and upgrade licensed services.
Wireless
Controller
Configuration
Configure how the UAG handles APs that newly connect to the
network.
AP
Management
Mgnt. AP List
Edit wireless AP information, remove APs, and reboot them.
Network
Interface
Port Grouping
Use this screen to configure port groups and set the UAG’s flexible
ports as WAN1, WAN2, LAN1, LAN2 or DMZ.
Ethernet
Manage Ethernet interfaces and virtual Ethernet interfaces.
PPP
Create and manage PPPoE and PPTP interfaces.
VLAN
Create and manage VLAN interfaces and virtual VLAN interfaces.
Bridge
Create and manage bridges and virtual bridge interfaces.
Trunk
Create and manage trunks (groups of interfaces) for load
balancing.
Routing
Policy Route
Create and manage routing policies.
Static Route
Create and manage IP static routing information.
Zone
Configure zones used to define various policies.
DDNS
Define and manage the UAG’s DDNS domain names.
NAT
Set up and manage port forwarding rules.
VPN 1-1
Mapping
General
Enable and configure VPN 1-1 mapping to assign a public IP
address to each of users that match the rules.
Profile
Configure a pool profile which defines the public IP address that the
UAG assigns to the matched users and the interface through which
the user’s traffic is forwarded.
HTTP Redirect
Set up and manage HTTP redirection rules.
SMTP Redirect
Set up and manage SMTP redirection rules.
ALG
Configure SIP, H.323, and FTP pass-through settings.
UPnP
enable UPnP and NAT-PMP on your UAG.
IP/MAC
Binding
Summary
Configure IP to MAC address bindings for devices connected to
each supported interface.
Exempt List
Configure ranges of IP addresses to which the UAG does not apply
IP/MAC binding.
Layer 2
Isolation
General
Enable layer-2 isolation on the UAG and the internal interface(s).
White List
Enable and configure the white list.
IPnP
Enable IPnP on the UAG and the internal interface(s).
Web
Authentication
Web Authentication Define rules to force user authentication for network access.
Walled Garden
Create walled garden links that display in the login screen.
Advertisement
Enable and set advertisement links.
Firewall
Firewall
Create and manage level-3 traffic rules.
Session Control
Limit the number of concurrent client NAT/firewall sessions.
Billing
General
Configure the general billing settings, such as the accounting
method.
Table 6
Configuration Menu Screens Summary (continued)
FOLDER OR LINK TAB
FUNCTION
