Chapter 35 Services
UAG5100 User’s Guide
361
The following table describes the labels in this screen.
35.2.1 The Service Add/Edit Screen
The Service Add/Edit screen allows you to create a new service or edit an existing one. To access
this screen, go to the Service screen (see
), and either click the Add icon
or select an entry and click the Edit icon.
Figure 238
Configuration > Object > Service > Service > Add/Edit
The following table describes the labels in this screen.
Table 164
Configuration > Object > Service > Service
LABEL
DESCRIPTION
Add
Click this to create a new entry.
Edit
Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove
To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
Object Reference Select an entry and click Object Reference to open a screen that shows which settings
use the entry. See
for an example.
#
This field is a sequential value, and it is not associated with a specific service.
Name
This field displays the name of each service.
Content
This field displays a description of each service.
Table 165
Configuration > Object > Service > Service > Add/Edit
LABEL
DESCRIPTION
Name
Type the name used to refer to the service. You may use 1-31 alphanumeric characters,
underscores(
_
), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
IP Protocol
Select the protocol the service uses. Choices are: TCP, UDP, ICMP, and User Defined.
Starting Port
Ending Port
This field appears if the IP Protocol is TCP or UDP. Specify the port number(s) used by
this service. If you fill in one of these fields, the service uses that port. If you fill in both
fields, the service uses the range of ports.
ICMP Type
This field appears if the IP Protocol is ICMP.
Select the ICMP message used by this service. This field displays the message text, not the
message number.
IP Protocol
Number
This field appears if the IP Protocol is User Defined.
Enter the number of the next-level protocol (IP protocol). Allowed values are 1 - 255.
OK
Click OK to
save your changes back to the UAG.
Cancel
Click Cancel to exit this screen without saving your changes.
