Chapter 41 System
UAG5100 User’s Guide
429
41.10 FTP
You can upload and download the UAG’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. Please see
for more
information about firmware and configuration files.
41.10.1 Configuring FTP
To change your UAG’s FTP settings, click Configuration > System > FTP tab. The screen appears
as shown. Use this screen to specify from which zones FTP can be used to access the UAG. You can
also specify from which IP addresses the access can come.
Figure 298
Configuration > System > FTP
#
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the UAG’s (non-configurable) default
policy. The UAG applies this to traffic that does not match any other configured rule. It is
not an editable rule. To apply other behavior, configure a rule that traffic will match so the
UAG will not have to use the default policy.
Zone
This is the zone on the UAG the user is allowed or denied to access.
Address
This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
Action
This displays whether the computer with the IP address specified above can access the
UAG zone(s) configured in the Zone field (Accept) or not (Deny).
Apply
Click Apply to save your changes back to the UAG.
Reset
Click Reset to return the screen to its last-saved settings.
Table 198
Configuration > System > TELNET (continued)
LABEL
DESCRIPTION
