Chapter 30 IPSec VPN
UAG5100 User’s Guide
291
30.2.1 The VPN Connection Add/Edit Screen
The Add/Edit VPN Connection screen allows you to create a new VPN connection policy or edit an
existing one. To access this screen, go to the Configuration > VPN > IPSec VPN > VPN
Connection screen (see
), and either click the Add icon or select an
entry and click the Edit icon.
Connect
To connect an IPSec SA, select it and click Connect.
Disconnect
To disconnect an IPSec SA, select it and click Disconnect.
Object
Reference
Select an entry and click Object Reference to open a screen that shows which settings use
the entry. See
#
This field is a sequential value, and it is not associated with a specific connection.
Status
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is disconnected.
Name
This field displays the name of the IPSec SA.
VPN Gateway
This field displays the associated VPN gateway(s).
Encapsulation
This field displays what encapsulation the IPSec SA uses.
Algorithm
This field displays what encryption and authentication methods, respectively, the IPSec SA
uses.
Policy
This field displays the local policy and the remote policy, respectively.
Apply
Click Apply to save your changes back to the UAG.
Reset
Click Reset to return the screen to its last-saved settings.
Table 131
Configuration > VPN > IPSec VPN > VPN Connection (continued)
LABEL
DESCRIPTION