Chapter 41 System
UAG5100 User’s Guide
400
To get the UAG date and time from a time server
1
Click System > Date/Time.
2
Select Get from Time Server under Time and Date Setup.
3
Under Time Zone Setup, select your Time Zone from the list.
4
As an option you can select the Enable Daylight Saving check box to adjust the UAG clock for
daylight savings.
5
Under Time and Date Setup, enter a Time Server Address (
6
Click Apply.
41.5 Console Port Speed
This section shows you how to set the console port speed when you connect to the UAG via the
console port using a terminal emulation program. See
for default console port
settings.
Click Configuration > System > Console Speed to open the Console Speed screen.
Figure 264
Configuration > System > Console Speed
The following table describes the labels in this screen.
Table 188
Configuration > System > Console Speed
LABEL
DESCRIPTION
Console Port Speed Use the drop-down list box to change the speed of the console port. Your UAG supports
9600, 19200, 38400, 57600, and 115200 bps (default) for the console port.
The Console Port Speed applies to a console port connection using terminal emulation
software and NOT the Console in the UAG Web Configurator Status screen.
Apply
Click Apply to save your changes back to the UAG.
Reset
Click Reset to return the screen to its last-saved settings.
