Chapter 47 Diagnostics
ZyWALL USG Series User’s Guide
1014
The following table describes the labels in this screen.
47.9 The Wireless Frame Capture Screen
Use this screen to capture wireless network traffic going through the AP interfaces connected to your
Zyxel Device. Studying these frame captures may help you identify network problems.
Click
Maintenance > Diagnostics > Wireless Frame Capture
to display this screen.
Note: New capture files overwrite existing files of the same name. Change the
File Prefix
field’s setting to avoid this.
Table 413 Maintenance > Diagnostics > Routing Traces
LABEL
DESCRIPTION
IP Address
You can trace traffic through the Zyxel Device from a specific source-to-destination
stream or just from/to a specific host (source or destination).
Source
Enter the source IP address of traffic that you want to trace.
Port
Enter the source port number of traffic that you want to trace.
Destination
Enter the destination IP address of traffic that you want to trace.
Port
Enter the destination port number of traffic that you want to trace.
Host
Enter the IP address of a specific source or destination host whose traffic you want to
trace.
Port
Enter the port number for particular source traffic on the host that you want to trace.
Protocol
Select the protocol of traffic that you want to trace.
any
means any protocol.
Interval
Enter a time interval in seconds for renewing a route trace. The default time interval is 5
seconds.
Capture
Click this button to have the Zyxel Device capture frames according to the settings
configured in this screen.
You can configure the Zyxel Device while a frame capture is in progress although you
cannot modify the frame capture settings.
Flush Data
Click this to clear all data on the screen.
Session
This field displays established sessions that passed through the Zyxel Device which
matched the capture criteria.
ID
This field displays the packet ID for each active session.
Protocol
This field displays the protocol used in each active session.
from VPN ID
This field displays the tagged VLAN ID in ingress packets coming into the Zyxel Device.
to VPN ID
This field displays the tagged VLAN ID in egress packets going out from the Zyxel Device.
Incoming Interface
This is the source interface of packets to which this active session applies.
Message
This field displays traceroute information.
Summary of Contents for USG110
