Chapter 10 Interfaces
ZyWALL USG Series User’s Guide
350
10.8.2 Tunnel Add or Edit Screen
This screen lets you configure a tunnel interface. Click
Configuration > Network > Interface > Tunnel >
Add
(or
Edit
)
to open the following
screen.
Status
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
Name
This field displays the name of the interface.
IP Address
This is the IP address of the interface. If the interface is active (and connected), the Zyxel
Device tunnels local traffic sent to this IP address to the
Remote Gateway Address
.
Tunnel Mode
This is the tunnel mode of the interface (
GRE
,
IPv6-in-IPv4
or
6to4
). This field also displays the
interface’s IPv4 IP address and subnet mask if it is a GRE tunnel. Otherwise, it displays the
interface’s IPv6 IP address and prefix length.
My Address
This is the interface or IP address uses to identify itself to the remote gateway. The Zyxel
Device uses this as the source for the packets it tunnels to the remote gateway.
Remote Gateway
Address
This is the IP address or domain name of the remote gateway to which this interface tunnels
traffic.
Apply
Click
Apply
to save your changes back to the Zyxel Device.
Reset
Click
Reset
to begin configuring this screen afresh.
Table 117 Network > Interface > Tunnel (continued)
LABEL
DESCRIPTION
Summary of Contents for USG110
