Chapter 10 Interfaces
ZyWALL USG Series User’s Guide
391
Figure 274
Configuration > Network > Interface > VTI > Add
Each field is described in the table below.
Table 129 Configuration > Network > Interface > VTI > Add
LABEL
DESCRIPTION
General Settings
Enable
Select this to enable VTI. Clear this to disable it.
Interface Properties
Interface Name
This field is read-only if you are editing an existing VPN tunnel interface. For a new VPN
tunnel interface, enter the name of the VPN tunnel interface in vtix format, where x is a
number from 0 to the maximum number of VPN connections allowed for this model. For
example, enter vti10.
Zone
Select a zone. Make sure that the zone you select does not have traffic blocked by a
security feature such as a security policy.
vpn-rule
You should have created a VPN tunnel first for a
VPN Tunnel Interface
scenario. Select one
of the
VPN Tunnel Interface
scenario rules that you created.
IP Address
Assignment
Summary of Contents for USG110
