Chapter 43 Object
ZyWALL USG Series User’s Guide
830
The following table describes the labels in this screen.
43.4.4 Technical Reference
The following section contains additional technical information about the features described in this
chapter.
Rogue APs
Rogue APs are wireless access points operating in a network’s coverage area that are not under the
control of the network’s administrators, and can open up holes in a network’s security. Attackers can
take advantage of a rogue AP’s weaker (or non-existent) security to gain access to the network, or set
up their own rogue APs in order to capture information from wireless clients. If a scan reveals a rogue AP,
you can use commercially-available software to physically locate it.
Table 313 Configuration > Object > MON Profile > Add/Edit MON Profile
LABEL
DESCRIPTION
Activate
Select this to activate this monitor mode profile.
Profile Name
This field indicates the name assigned to the monitor mode profile.
Channel dwell time
Enter the interval (in milliseconds) before the AP switches to another channel for
monitoring.
Scan Channel Mode
Select
auto
to have the AP switch to the next sequential channel once the
Channel dwell
time
expires.
Select
manual
to set specific channels through which to cycle sequentially when the
Channel dwell time
expires. Selecting this options makes the
Scan Channel List
options
available.
Country Code
Select the country code of APs that are connected to the Zyxel Device to be the same as
where the Zyxel Device is located/installed.
The available channels vary depending on the country you selected. Be sure to select the
correct/same country for both radios on an AP and all connected APs, in order to prevent
roaming failure and interference to other systems.
After changing the country code, the AP channel setting will be reset if your manually
selected channel(s) are not valid in the new country code setting.
Set Scan Channel List
(2.4 GHz)
Move a channel from the
Available channels
column to the
Channels selected
column to
have the APs using this profile scan that channel when
Scan Channel Mode
is set to
manual.
These channels are limited to the 2 GHz range (802.11 b/g/n).
Set Scan Channel List
(5 GHz)
Move a channel from the
Available channels
column to the
Channels selected
column to
have the APs using this profile scan that channel when
Scan Channel Mode
is set to
manual.
These channels are limited to the 5 GHz range (802.11 a/n).
OK
Click
OK
to
save your changes back to the Zyxel Device.
Cancel
Click
Cancel
to exit this screen without saving your changes.
Summary of Contents for USG110
