Chapter 44 System
ZyWALL USG Series User’s Guide
962
The following table describes the fields in the ZON Utility main screen.
44.17.3 Zyxel One Network (ZON) System Screen
Enable
ZDP
(ZON) and
Smart Connect
(Ethernet Neighbor) in the
System > ZON
screen.
See
Monitor > System Status > Ethernet Neighbor
for information on using
Smart Connect
(Link Layer
Discovery Protocol (LLDP)) for discovering and configuring LLDP-aware devices in the same broadcast
domain as the Zyxel Device that you’re logged into using the web configurator.
The following figure shows the
System > ZON
screen.
9 Configure NCC
Discovery
You must have Internet access to use this feature. Use this icon to enable or disable
Nebula Control Center (NCC) discovery on the selected device. If it’s enabled, the
selected device will try to connect to the NCC. Once the selected device is
connected to and has registered in the NCC, it’ll go into the cloud management
mode.
10 ZAC
Use this icon to run the Zyxel AP Configurator of the selected AP.
11 Clear and Rescan
Use this icon to clear the list and discover all devices on the connected network
again.
12 Save Configuration
Use this icon to save configuration changes to permanent memory on a selected
device.
13 Settings
Use this icon to select a network adaptor for the computer on which the ZON utility is
installed, and the utility language.
Table 390 ZON Utility Fields
LABEL
DESCRIPTION
Type
This field displays an icon of the kind of device discovered.
Model
This field displays the model name of the discovered device.
Firmware Version
This field displays the firmware version of the discovered device.
MAC Address
This field displays the MAC address of the discovered device.
IP Address
This field displays the IP address of an internal interface on the discovered device that
first received an ZDP discovery request from the ZON utility.
System Name
This field displays the system name of the discovered device.
Location
This field displays where the discovered device is.
Status
This field displays whether changes to the discovered device have been done
successfully. As the Zyxel Device does not support
IP Configuration
,
Renew IP address
and
Flash Locator LED
, this field displays “Update failed”, “Not support Renew IP
address” and “Not support Flash Locator LED” respectively.
NCC Discovery
This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it’s enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it’ll go into
the cloud management mode.
Serial Number
Enter the admin password of the discovered device to display its serial number.
Hardware Version
This field displays the hardware version of the discovered device.
Table 389 ZON Utility Icons
ICON
DESCRIPTION
Summary of Contents for USG110
