Chapter 6 Dashboard
ZyWALL USG Series User’s Guide
191
6.2.8 Secured Service Status Screen
This part shows what Unified Threat Management (UTM) services are available and enabled.
Figure 161
Dashboard > Secured Service Status
This table describes the fields in the above screen.
HA Status
This field displays the status of the interface in the virtual router.
Active
- This interface is the master interface in the virtual router.
Stand-By
- This interface is a backup interface in the virtual router.
Fault
- This VRRP group is not functioning in the virtual router right now. For example,
this might happen if the interface is down.
n/a
- Device HA is not active on the interface.
Zone
This field displays the zone to which the interface is currently assigned.
IP Addr/Netmask
This field displays the current IP address and subnet mask assigned to the interface. If
the IP address is 0.0.0.0/0.0.0.0, the interface is disabled or did not receive an IP
address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays the IP
address it is currently using. This is either the static IP address of the interface (if it is
the master) or the management IP address (if it is a backup).
IP Assignment
This field displays the interface’s IP assignment. It will show
DHCP
or
Static
.
Action
Use this field to get or to update the IP address for the interface.
Click
Renew
to send a new DHCP request to a DHCP server.
Click the
Connect
icon to have the Zyxel Device try to connect a PPPoE/PPTP
interface. If the interface cannot use one of these ways to get or to update its IP
address, this field displays
n/a
.
Click the
Disconnect
icon to stop a PPPoE/PPTP connection.
Table 29 Dashboard > Interface Status Summary (continued)
LABEL
DESCRIPTION
Table 30 Dashboard > Secured Service Status
LABEL
DESCRIPTION
#
This field is a sequential value, and it is not associated with a specific status.
Status
This field displays the status of the Zyxel Device’s secure services. It will show four
types of status,
Activated
or
Not Activated
or
Disabled
or
Enabled
.
Name
This field displays the name of the service, for example
Anti-Spam
.
Summary of Contents for USG110
