Chapter 10 Interfaces
ZyWALL USG Series User’s Guide
401
10.15 Interface Technical Reference
Here is more detailed information about interfaces on the Zyxel Device.
IP Address Assignment
Most interfaces have an IP address and a subnet mask. This information is used to create an entry in the
routing table.
Mode
This field displays
Active
if the Zyxel Device always attempt to use this connection.
This field displays
Passive
if the Zyxel Device only use this connection when all of the
connections set to active are down. Only one of a group’s interfaces can be set to
passive mode.
Weight
This field displays with the weighted round robin load balancing algorithm. Specify the
weight (1~10) for the interface. The weights of the different member interfaces form a
ratio. s
Ingress Bandwidth
This is reserved for future use.
This field displays with the least load first load balancing algorithm. It displays the
maximum number of kilobits of data the Zyxel Device is to allow to come in through the
interface per second.
Egress Bandwidth
This field displays with the least load first or spillover load balancing algorithm. It displays
the maximum number of kilobits of data the Zyxel Device is to send out through the
interface per second.
Spillover
This field displays with the spillover load balancing algorithm. Specify the maximum
bandwidth of traffic in kilobits per second (1~1048576) to send out through the interface
before using another interface. When this spillover bandwidth limit is exceeded, the Zyxel
Device sends new session traffic through the next interface. The traffic of existing sessions
still goes through the interface on which they started.
The Zyxel Device uses the group member interfaces in the order that they are listed.
OK
Click
OK
to save your changes back to the Zyxel Device.
Cancel
Click
Cancel
to exit this screen without saving.
Table 133 Configuration > Network > Interface > Trunk > Edit (System Default) (continued)
LABEL
DESCRIPTION
Summary of Contents for USG110
