Chapter 11 Routing
ZyWALL USG Series User’s Guide
427
The following table describes the labels in this screen.
11.8 BGP (Border Gateway Protocol)
The Zyxel Device supports eBGP (exterior Border Gate Protocol) to route IPv4 traffic between routers in
different Autonomous Systems (AS). An AS number is a number from 1 to 4294967295), that identifies an
autonomous system. 4200000000 – 4294967294 are private AS numbers.
See
for more information on autonomous systems.
Figure 296
eBGP Concept
Table 147 Configuration > Network > Routing > OSPF > Add > Add
LABEL
DESCRIPTION
Peer Router ID
Enter the 32-bit ID (in IP address format) of the other ABR in the virtual link.
Authentication
Select the authentication method the virtual link uses. This authentication protects the
integrity, but not the confidentiality, of routing updates.
For OSPF, the Zyxel Device supports a default authentication type by area. If you want to
use this default in an interface or virtual link, you set the associated Authentication Type
field to
Same as Area
. As a result, you only have to update the authentication information
for the area to update the authentication type used by these interfaces and virtual links.
Alternatively, you can override the default in any interface or virtual link by selecting a
specific authentication method. Please see the respective interface sections for more
information.
None
uses no authentication.
Text
uses a plain text password that is sent over the network (not very secure).
MD5
uses an MD5 password and authentication ID (most secure).
Same as Area
has the virtual link also use the
Authentication
settings above.
Text Authentication
Key
This field is available if the
Authentication
is
Text
. Type the password for text authentication.
The key can consist of alphanumeric characters and the underscore, and it can be up to
16 characters long.
MD5 Authentication
ID
This field is available if the
Authentication
is
MD5
. Type the default ID for MD5
authentication in the area. The ID can be between 1 and 255.
MD5 Authentication
Key
This field is available if the
Authentication
is
MD5
. Type the default password for MD5
authentication in the area. The password can consist of alphanumeric characters and the
underscore, and it can be up to 16 characters long.
OK
Click
OK
to save your changes back to the Zyxel Device.
Cancel
Click
Cancel
to exit this screen without saving.
Summary of Contents for USG110
