Chapter 44 System
ZyWALL USG Series User’s Guide
946
44.10 FTP
You can upload and download the Zyxel Device’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client.
44.10.1 Configuring FTP
To change your Zyxel Device’s FTP settings, click
Configuration > System > FTP
tab. The screen appears
as shown. Use this screen to specify from which zones FTP can be used to access the Zyxel Device. You
can also specify from which IP addresses the access can come.
Figure 674
Configuration > System > FTP
#
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the Zyxel Device’s (non-configurable) default
policy. The Zyxel Device applies this to traffic that does not match any other configured rule. It
is not an editable rule. To apply other behavior, configure a rule that traffic will match so the
Zyxel Device will not have to use the default policy.
Zone
This is the zone on the Zyxel Device the user is allowed or denied to access.
Address
This is the object name of the IP address(es) with which the computer is allowed or denied to
access.
Action
This displays whether the computer with the IP address specified above can access the Zyxel
Device zone(s) configured in the
Zone
field (
Accept
) or not (
Deny
).
Apply
Click
Apply
to save your changes back to the Zyxel Device.
Reset
Click
Reset
to return the screen to its last-saved settings.
Table 378 Configuration > System > TELNET (continued)
LABEL
DESCRIPTION
Summary of Contents for USG110
