41
3.
Click on [Add] tab. You will see the following screen.
4.
Configure [Add Access Control List (ACL)] Settings following the instructions below
Sequence Number
This defines the sequence of the ACL rules. If a packet fits the conditions set
by the ACL rules, the packet will then be sorted according to the first ACL rule
from the top of the list.
Rule Name
Name of the ACL rule.
Rule Enable
Enable/Disable this ACL rule
External Interface
Please select which External Interface (WAN1 or WAN2) you want a packet to
go through, IF the packet fits the condition of this ACL rule.
Internal IP Range
Set up the internal IP range for this ACL rule.
External IP Range
Set up the external IP range for this ACL rule.
Protocol
Set up the protocol (TCP or UDP) for the ACL to be enabled.
Service Port Range
Set up the Service Port Range (e.g., HTTP is TCP/80) for the ACL to be
enabled.
Action
Select ALLOW / DENY
。
Summary of Contents for VFG6005
