Chapter 10 Wireless LAN
WRE6606 User’s Guide
76
assign varying security types and to different SSIDs. Wireless clients can use different SSIDs to
associate with the same access point.
Figure 55
Network > Wireless LAN 2.4G/5G > Guest WLAN
The following table describes the labels in this screen.
Table 28
Network > Wireless LAN 2.4G/5G > Guest WLAN
LABEL
DESCRIPTION
Guest WLAN Setup
Guest WLAN
Select
Enable
to activate the guest wireless LAN. Select
Disable
to turn it off.
Network Name
(SSID)
The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Guest IP Address
Type an IP address for the devices on the Guest WLAN using this as the gateway IP
address.
Guest Subnet
Mask
Type the subnet mask for the guest wireless LAN.
Guest Start IP
This field displays the first IP address of guest wireless LAN.
Guest End IP
This field displays the last IP address of guest wireless LAN.
Security
Security Mode
Select Static
WEP
,
WPA-PSK
, and
WPA2-PSK
to add security on this wireless network.
The wireless clients which want to associate to this network must have the same wireless
security settings as this device. After you select to use a security, additional options
appears in this screen. See
for detailed information on different
security modes. Or you can select
No Security
to allow any client to associate this
network without authentication
Note: If the WPS function is enabled (default), only
No Security
and
WPA2-PSK
are
available in this field.