Chapter 33 sFlow
XGS4600 Series User’s Guide
346
The following table describes the labels in this screen.
Table 148 Advanced Application > sFlow > Collector
LABEL
DESCRIPTION
Collector
Address
Enter the IP address of the sFlow collector.
UDP Port
Enter a UDP port number the Switch uses to send sFlow datagram to the collector. If you change
the port here, make sure you change it on the collector, too. The default port is 6343.
Add
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the
Save
link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to reset the fields to your previous configuration.
Clear
Click
Clear
to reset the fields to the factory defaults.
Index
This field displays the index number of this entry. Click on an index number to change the
settings.
Collector
Address
This field displays IP address of the sFlow collector.
UDP Port
This field displays port number the Switch uses to send sFlow datagram to the collector.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete
Check the rules that you want to remove in the
Delete
column and then click the
Delete
button.
Cancel
Click
Cancel
to begin configuring this screen afresh.
