Chapter 55 VRRP
XGS4600 Series User’s Guide
503
Note: Routing domains with the same VLAN ID are not displayed in the table indicated.
Figure 406
IP Application > VRRP Configuration: IP Interface
The following table describes the labels in this screen.
55.3.2 VRRP Parameters
This section describes the VRRP parameters.
Table 243 IP Application > VRRP Configuration: IP Interface
LABEL
DESCRIPTION
Index
This field displays the index number of an entry.
Network
This field displays the IP address and number of subnet mask bit of an IP domain.
Authentication
Select
None
to disable authentication. This is the default setting.
Select
Simple
to use a simple password to authenticate VRRP packet exchanges on this
interface.
Key
When you select
Simple
in the
Authentication
field, enter a password key (up to eight printable
ASCII character long) in this field.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to discard all changes made in this table.
