Chapter 25 Multicast
XGS4600 Series User’s Guide
268
25.4 IPv6 Multicast Status
Click
Advanced Application
>
Multicast
>
IPv6 Multicast
to display the screen as shown. This screen
shows the IPv6 multicast group information. See
for more information on
multicasting.
Figure 207
Advanced Application > Multicast > IPv6 Multicast
The following table describes the fields in the above screen.
25.4.1 MLD Snooping-proxy
Click the
MLD Snooping-proxy
link in the
Advanced Application
>
Multicast
>
IPv6 Multicast
screen to
display the screen as shown. See
for more information on multicasting.
Add
Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the
Save
link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to reset the fields to the factory defaults.
Profile Name
This field displays the descriptive name of the profile.
Start Address
This field displays the start of the multicast address range.
End Address
This field displays the end of the multicast address range.
Delete Profile
Select a profile’s check box to select a specific profile. Otherwise, select the check box in the
table heading row to select all profiles.
Delete Rule
Select the check boxes of the rules that you want to remove from a profile.
Delete
To delete the profiles and all the accompanying rules, select the profiles that you want to
remove in the
Delete Profile
column, then click the
Delete
button.
To delete a rules from a profile, select the rules that you want to remove in the
Delete Rule
column, then click the
Delete
button.
Cancel
Click
Cancel
to clear the
Delete Profile
or
Delete Rule
check boxes.
Table 104 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering Profile
LABEL
DESCRIPTION
Table 105 Advanced Application > Multicast > IPv6 Multicast
LABEL
DESCRIPTION
Index
This is the index number of the entry.
VID
This field displays the multicast VLAN ID.
Port
This field displays the port number that belongs to the multicast group. In stacking mode,
the first number represents the slot and the second is the port number.
Multicast Group
This field displays IP multicast group addresses.
Group Timeout
This field displays the time (in seconds) that elapses before the Switch removes a MLD group
membership entry if it does not receive report messages from the port.
