Chapter 5 Initial Setup Example
XGS4600 Series User’s Guide
63
1
Click
Advanced Applications
>
VLAN
>
VLAN
Configuration
in the navigation panel. Then
click the
VLAN Port Setup
link.
2
Enter 2 in the
PVID
field for port 1 and click
Apply
to save your changes back to the run-
time memory. Settings in the run-time memory
are lost when the Switch’s power is turned off.
5.1.3 Configure Switch Management IP Address
If the Switch fails to obtain an IP address from a DHCP server, the Switch will use 192.168.1.1 as the
management IP address. You can configure another IP address in a different subnet for management
purposes. The following figure shows an example.
Figure 40
Initial Setup Example: Management IP Address
1
Connect your computer to any Ethernet port on the Switch. Make sure your computer is in the same
subnet as the Switch.
2
Open your web browser and enter 192.168.1.1 (the default IP address) in the address bar to access the
Web Configurator. See
for more information.
3
Click
Basic Setting
>
IP Setup
>
IP Configuration
in the navigation panel.
