Chapter 8 Basic Setting
XGS4600 Series User’s Guide
99
8.8 Interface Setup
An IPv6 address is configured on a per-interface basis. The interface can be a physical interface (for
example, an Ethernet port) or a virtual interface (for example, a VLAN). The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Use this screen to set IPv4 loopback interfaces for routing protocols or IPv6 interfaces on which you can
configure an IPv6 address to access and manage the Switch.
Click
Basic Setting
>
Interface Setup
in the navigation panel to display the configuration screen.
Figure 75
Basic Setting > Interface Setup
BPDU Control
Configure the way to treat BPDUs received on this port. You must activate bridging control
protocol transparency in the Switch
Setup
screen first.
Select
Peer
to process any BPDU (Bridge Protocol Data Units) received on this port.
Select
Tunnel
to forward BPDUs received on this port.
Select
Discard
to drop any BPDU received on this port.
Select
Network
to process a BPDU with no VLAN tag and forward a tagged BPDU.
Media Type
You can insert either an SFP+ transceiver or an SFP+ Direct Attach Copper (DAC) cable into the
10 Gigabit interface of the Switch.
Select the media type (
sfp_plus
or
dac10g
) of the SFP+ module that is attached to the 10
Gigabit interface.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 22 Basic Setting > Port Setup (continued)
LABEL
DESCRIPTION
