Chapter 24 Multicast
XS1930 Series User’s Guide
202
End Address
Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the
Start Address
and
End
Address
fields.
Add
Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the
Save
link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to reset the fields to the factory defaults.
Profile Name
This field displays the descriptive name of the profile.
Start Address
This field displays the start of the multicast address range.
End Address
This field displays the end of the multicast address range.
Delete Profile
Select a profile’s check box to select a specific profile. Otherwise, select the check box in the
table heading row to select all profiles.
Delete Rule
Select the check box(es) of the rule(s) that you want to remove from a profile.
Delete
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want to
remove in the
Delete Profile
column, then click the
Delete
button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the
Delete Rule
column, then click the
Delete
button.
Cancel
Click
Cancel
to clear the
Delete Profile
/
Delete Rule
check boxes.
Table 94 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering Profile
LABEL
DESCRIPTION
