Chapter 31 Link Layer Discovery Protocol (LLDP)
XS1930 Series User’s Guide
251
31.6.2 Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click
Advanced Application
>
LLDP > LLDP
Configuration (Click Here) > Org-specific TLV Setting
to display the screen as shown next.
Figure 178
Advanced Application > LLDP > LLDP Configuration> Org-specific TLV Setting
The following table describes the labels in this screen.
System Capabilities
Select the check box(es) to enable or to disable the sending of System Capabilities TLVs on
the port(s).
System Description
Select the check box(es) to enable or to disable the sending of System Description TLVs on
the port(s).
System Name
Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 125 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
DESCRIPTION
Table 126 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
DESCRIPTION
Port
This displays the Switch’s port number. * means all ports.
*
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Dot1 TLV
Port VLAN ID
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the port(s). All check boxes in this column are enabled by default.
Dot3 TLV
Link
Aggregation
Select the check box(es) to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the port(s).
