Chapter 34 ARP Setup
XS1930 Series User’s Guide
279
Figure 200
IP Application > ARP Setup > Static ARP
The following table describes the related labels in this screen.
Table 144 IP Application > ARP Setup > Static ARP
LABEL
DESCRIPTION
Active
Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Name
Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
IP Address
Enter the IP address of a device connected to a Switch port with the corresponding MAC
address below.
MAC Address
Enter the MAC address of the device with the corresponding IP address above.
VID
Enter the ID number of VLAN to which the device belongs.
Port
Enter the number of port to which the device connects.
Add
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the
Save
link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Clear Click
Clear
to set the above fields back to the factory defaults.
Index
This field displays the index number of an entry. Click an index number to change the settings.
Active
This field displays
Yes
when the entry is activated and
NO
when it is deactivated.
Name
This field displays the descriptive name for this entry. This is for identification purposes only.
IP Address
This is the IP address of a device connected to a Switch port with the corresponding MAC
address below.
MAC Address
This is the MAC address of the device with the corresponding IP address above.
VID
This field displays the VLAN to which the device belongs.
Port
This field displays the port to which the device connects.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete
Click
Delete
to remove the selected entry from the summary table.
Cancel
Click
Cancel
to clear the check boxes.
