Chapter 37 Diagnostic
XS1930 Series User’s Guide
314
The following table describes the labels in this screen.
Table 165 Management > Diagnostic
LABEL
DESCRIPTION
Ping Test
IPv4
Select this option if you want to ping an IPv4 address. Select
-
to send ping requests to all
VLANs on the Switch.
IPv6
Select this option if you want to ping an IPv6 address. You can also select
vlan
and specify
the ID number of the VLAN to which the Switch is to send ping requests. Otherwise, select
-
to
send ping requests to all VLANs on the Switch.
IP Address/Host
Name
Type the IP address or host name of a device that you want to ping in order to test a
connection.
Click
Ping
to have the Switch ping the IP address.
Source IP
Address
Type the source IP address that you want to ping in order to test a connection.
Click
Ping
to have the Switch ping the IP address.
Count
Enter the number of ICMP Echo Request (ping) messages the Switch continuously sends.
Trace Route Test
IPv4
Select this option if you want to trace the route packets take to a device with an IPv4
address. Select
-
to trace the path on any VLAN.
Note: The device to which you want to run a traceroute must belong to the VLAN
you specify here.
IPv6
Select this option if you want to trace the route packets take to a device with an IPv6
address.
IP Address/Host
Name
Enter the IP address or host name of a device to which you want to perform a traceroute.
Click
Trace Route
to have the Switch perform the traceroute function. This determines the
path a packet takes to the specified device.
TTL
Enter the Time To Live (TTL) value for the ICMP Echo Request packets. This is to set the
maximum number of the hops (routers) a packet can travel through. Each router along the
path will decrement the TTL value by one and forward the packets. When the TTL value
becomes zero and the destination is not found, the router drops the packets and informs the
sender.
Wait Time
Specify how many seconds the Switch waits for a response to a probe before running
another traceroute.
Queries
Specify how many times the Switch performs the traceroute function.
Ethernet Port Test
Enter a port number and click
Port Test
to perform an internal loopback test.
Cable Diagnostics
Enter an Ethernet port number and click
Diagnose
to perform a physical wire-pair test of the
Ethernet connections on the specified port(s). The following fields display in the
Diagnostic
field when you diagnose a port.
This field is available only on the Switch that has one or more copper Ethernet ports (except
the
MGMT
port).
Note: The Switch measures the cable length by sending an electric signal through
the cable and reading the signal that is reflected back. To prevent possible
interference from a connected device, it's suggested that you disconnect
the other end of the Ethernet cable which is connected to the specified
port.
Port
This is the number of the physical Ethernet port on the Switch.
Channel
An Ethernet cable usually has four pairs of wires. A 10BASE-T or 100BASE-TX port only use and
test two pairs, while a 1000BASE-T port requires all four pairs.
This displays the descriptive name of the wire-pair in the cable.
