Chapter 39 Syslog Setup
XS1930 Series User’s Guide
318
Figure 235
Management > Syslog Setup
The following table describes the labels in this screen.
Table 167 Management > Syslog Setup
LABEL
DESCRIPTION
Syslog
Select
Active
to turn on syslog (system logging) and then configure the syslog setting
Logging Type
This column displays the names of the categories of logs that the device can generate.
Active
Select this option to set the device to generate logs for the corresponding category.
Facility
The log facility allows you to send logs to different files in the syslog server. Refer to the
documentation of your syslog program for more details.
Apply Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Syslog Server Setup
Active
Select this check box to have the device send logs to this syslog server. Clear the check box
if you want to create a syslog server entry but not have the device send logs to it (you can
edit the entry later).
Server Address
Enter the IPv4 or IPv6 address of the syslog server.
UDP Port
The default syslog server port is 514. If your syslog server uses a different port, configure the
one it uses here.
Log Level
Select the severity level(s) of the logs that you want the device to send to this syslog server.
The lower the number, the more critical the logs are.
