XS1930 Series User’s Guide
293
C
HAPTER
36
Access Control
36.1 Access Control Overview
This chapter describes how to control access to the Switch.
FTP is allowed one session. Telnet and SSH share nine sessions. Up to five Web sessions (five different user
names and passwords) and/or limitless SNMP access control sessions are allowed.
36.1.1 What You Can Do
• Use the
Access Control
screen (
) to display the main screen.
• Use the
SNMP
screen (
) to configure your SNMP settings.
• Use the
Trap Group
screen (
) to specify the types of SNMP traps that should
be sent to each SNMP manager.
• Use the
User Information
screen (
) to create SNMP users for authentication
with managers using SNMP v3 and associate them to SNMP groups.
• Use the
Logins
) to assign which users can access the Switch via
web configurator at any one time.
• Use the
Service Access Control
screen (
) to decide what services you may
use to access the Switch.
• Use the
Remote Management
) to specify a group of one or more
“trusted computers” from which an administrator may use a service to manage the Switch.
36.2 The Access Control Main Screen
Use this screen to display the main screen.
Click
Management
>
Access Control
in the navigation panel to display the main screen as shown.
Figure 213
Management > Access Control
Table 150 Access Control Overview
SSH
Telnet
FTP
Web
SNMP
Share up to nine sessions
One session
Up to five accounts No limit
