Chapter 17 Layer 2 Isolation
USG20(W)-VPN Series User’s Guide
289
17.2 Layer-2 Isolation General Screen
This screen allows you to enable Layer-2 isolation on the USG and specific internal interface(s). To
access this screen click
Configuration > Network > Layer 2 Isolation
.
Figure 197
Configuration > Network > Layer 2 Isolation
The following table describes the labels in this screen.
17.3 White List Screen
IP addresses that are not listed in the white list are blocked from communicating with other devices
in the layer-2-isolation-enabled internal interface(s) except for broadcast packets.
To access this screen click
Configuration > Network > Layer 2 Isolation > White List
.
Table 114
Configuration > Network > Layer 2 Isolation
LABEL
DESCRIPTION
Enable Layer2
Isolation
Select this option to turn on the layer-2 isolation feature on the USG.
Note: You can enable this feature only when the security policy is enabled.
Member List
The
Available
list displays the name(s) of the internal interface(s) on which you can
enable layer-2 isolation.
To enable layer-2 isolation on an interface, you can double-click a single entry to move it
or use the [Shift] or [Ctrl] key to select multiple entriess and click the right arrow button to
add to the
Member
list. To remove an interface, select the name(s) in the
Member
list
and click the left
arrow button.
Apply
Click
Apply
to save your changes back to the USG.
Reset
Click
Reset
to return the screen to its last-saved settings.
Summary of Contents for ZyWall USG20-VPN
Page 17: ...17 PART I User s Guide ...
Page 18: ...18 ...
Page 99: ...99 PART II Technical Reference ...
Page 100: ...100 ...