Chapter 30 System
USG20(W)-VPN Series User’s Guide
539
• Use the
System > ZON
screen (see
) to enable or disable the ZyXEL
One Network (ZON) utility that uses ZyXEL Discovery Protocol (ZDP) for discovering and
configuring ZDP-aware ZyXEL devices in the same network as the computer on which ZON is
installed.
Note: See each section for related background information and term definitions.
30.2 Host Name
A host name is the unique name by which a device is known on a network. Click
Configuration >
System > Host Name
to open the
Host Name
screen.
Figure 367
Configuration > System > Host Name
The following table describes the labels in this screen.
30.3 USB Storage
The USG can use a connected USB device to store the system log and other diagnostic information.
Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system.
Click
Configuration > System > USB Storage
to open the screen as shown next.
Table 229
Configuration > System > Host Name
LABEL
DESCRIPTION
System Name
Enter a descriptive name to identify your USG device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Domain Name
Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes “-” are accepted.
Apply
Click
Apply
to save your changes back to the USG.
Reset
Click
Reset
to return the screen to its last-saved settings.
Summary of Contents for ZyWall USG20-VPN
Page 17: ...17 PART I User s Guide ...
Page 18: ...18 ...
Page 99: ...99 PART II Technical Reference ...
Page 100: ...100 ...
