Chapter 6 Monitor
USG20(W)-VPN Series User’s Guide
106
6.4 The Traffic Statistics Screen
Click
Monitor > System Status > Traffic Statistics
to display the
Traffic Statistics
screen. This
screen provides basic information about the following for example:
• Most-visited Web sites and the number of times each one was visited. This count may not be
accurate in some cases because the USG counts HTTP GET packets. Please see
for more information.
• Most-used protocols or service ports and the amount of traffic on each one
Action
Use this field to get or to update the IP address for the interface. Click
Renew
to send a
new DHCP request to a DHCP server. Click
Connect
to try to connect a PPPoE/PPTP
interface. If the interface cannot use one of these ways to get or to update its IP address,
this field displays
n/a
.
Tunnel Interface
Status
This displays the details of the USG’s configured tunnel interfaces.
Name
This field displays the name of the interface.
Status
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
Zone
This field displays the zone to which the interface is assigned.
IP Address
This is the IP address of the interface. If the interface is active (and connected), the USG
tunnels local traffic sent to this IP address to the
Remote Gateway Address
.
My Address
This is the interface or IP address uses to identify itself to the remote gateway. The USG
uses this as the source for the packets it tunnels to the remote gateway.
Remote Gateway
Address
This is the IP address or domain name of the remote gateway to which this interface
tunnels traffic.
Mode
This field displays the tunnel mode that you are using.
Interface
Statistics
This table provides packet statistics for each interface.
Refresh
Click this button to update the information in the screen.
Name
This field displays the name of each interface. If there is a
Expand
icon (plus-sign) next to
the name, click this to look at the statistics for virtual interfaces on top of this interface.
Status
This field displays the current status of the interface.
•
Down
- The interface is not connected.
•
Speed / Duplex
- The interface is connected. This field displays the port speed and
duplex setting (
Full
or
Half
).
This field displays
Connected
and the accumulated connection time (hh:mm:ss) when the
PPP interface is connected.
TxPkts
This field displays the number of packets transmitted from the USG on the interface since
it was last connected.
RxPkts
This field displays the number of packets received by the USG on the interface since it was
last connected.
Tx B/s
This field displays the transmission speed, in bytes per second, on the interface in the one-
second interval before the screen updated.
Rx B/s
This field displays the reception speed, in bytes per second, on the interface in the one-
second interval before the screen updated.
Table 34
Monitor > System Status > Interface Status (continued)
LABEL
DESCRIPTION
Summary of Contents for ZyWall USG20-VPN
Page 17: ...17 PART I User s Guide ...
Page 18: ...18 ...
Page 99: ...99 PART II Technical Reference ...
Page 100: ...100 ...
