3M™ Wireless Drive Thru System Model G5
Upgrading XT-1 basestation to 3M™ Drive Thru Basestation G5
Overview
:
This document describes and illustrates the steps involved to successfully upgrade a 3M™ Wireless Communication System Model
XT-1 basestation with a 3M™ Drive Thru Basestation G5, in sites employing a Single Lane drive thru operation.
For the remainder of the document, the
•
3M™ Wireless Communication System Model XT-1 basestation
will be referred to as
XT-1 Basestation
, and
•
3M™ Drive Thru Basestation G5
referred to as
G5 Basestation
.
Pre-Requisites:
1.
Interview the Store Manager and verify they are currently NOT experiencing any issues with their Drive Thru equipment..
Otherwise, these issues need to be rectified first before conducting the Basestation upgrade.
2.
Use the Pre-Install Checklist (attached to this document) to capture
ALL
information related to Store Operation, and
Greeter functionality by
•
Checking and writing down the current settings on the XT-1 Basestation
•
Inspecting the XT-1 basestation for all connected peripherals (Timers, Greeters , External or |
•
Inspecting the XT-1 basestation for all connected peripherals (Timers, Greeters , External or |
Internal Vehicle Detectors, Pre-Approach Loops, etc
•
Interviewing the Store Manager for any desired changes in operation (such as OT Modes,, Range etc)
3.
Verify the cable to the outside Order Post is in good condition
4.
Inspect the Order Post to verify Speaker and Microphone are properly positioned and the post is treated with 3M
TM
Acoustic Kit.
IMPORTANT NOTES:
1.
The G5 Basestation allows for
ONLY ONE
internal Vehicle Detector Boar\d per Lane (for the Order Point Loop).
If the current XT-1 Basestation has more than one Internal Vehicle Detectors Board , ALL but tone (he Vehicle Detector Board
connected to the Order Point)
MUST
be replaced with External Detectors.
2.
The Greeter functionality is built into the G5 Basestation.
3.
All G5 Basestation configuration will have to be manually conducted either via the
-- Basestation’s Front Panel (Keypad and LCD Screen) or
-- Basestation’s Web Server
Any Configuration File you may have exported from the XT-1 Basestation cannot be imported/loaded onto the G5 Basestation.
1
