background image

SUBWOOFER

INSTRUCTIONS

SUB - 60

INSTRUCTIONS 

POWERED SUBWOOFER

Congratulations on choosing an "Aaron" subwoofer. We at Aaron have gone to the upmost trouble 
to ensure your continuing satisfaction for many years to come. Every individual subwoofer unit must 
meet our exact specifications with regard to performance and craftsmanship before it is allowed to 
leave our factory.

SAFETY INSTRUCTIONS

Make sure the voltage selector is set to your country`s voltage.   (Refer Fig. 1).

Always connect the unit to a standard AC wall outlet.

Run the power cord so it will not be damaged by being pinched, stretched, cut or walked on.

Never connect other inputs to the electricity mains.

When removing the power plug don't use wet hands or pull the plug out by the cord.

Remove the power plug from the wall if it is not in use for an extended period. For example when you 
go away on holidays.

Whenever changing wires, plugs etc., always have the power turned off.

If water is spilt on the unit always take extreme care to be sure the unit is completely dry before 
reconnecting it.

Don't operate the subwoofer too close to heaters.

If the Subwoofer makes a slight distortion noise you have the volume too high and have reached it's 
maximum output limit. Please lower the volume control.

Never use more than a small adjustment on your amplifier`s tone controls especially at high volumes.

Turn down the volume when changing a record or switching from one source to another.

Don't push in the speaker diaphragms with any force.

Do not expose the diaphragms to direct sunlight.

It is not advisable to place the unit in a damp environment.

Don't use solvents to clean any part of the unit.

Tampering with the internal parts of the unit may cause an electric shock or damage, not covered by 
warranty.

If a part fails, insist on a genuine replacement.

Do not put your ears too close to the speakers or play them too loud for extended period of time as 
this may cause partial hearing loss.

Beware! Cats love sharpening their claws on speaker cloth.

When you get your subwoofer check that it has not been damaged in transit. Please keep the original 
carton in case of future need, it folds flat and takes up little space.

Summary of Contents for SUB-60

Page 1: ...care to be sure the unit is completely dry before reconnecting it Don t operate the subwoofer too close to heaters If the Subwoofer makes a slight distortion noise you have the volume too high and have reached it s maximum output limit Please lower the volume control Never use more than a small adjustment on your amplifier s tone controls especially at high volumes Turn down the volume when changi...

Page 2: ...lume control will have to be set higher When using two subwoofers best results are obtained by connecting each unit to a different channel on the amplifier We do not supply speaker wire or RCA cable with the subwoofer because every installation is different It is important to use good quality cable and keep the length as short as practical In the case where cable is already wired through the house...

Page 3: ...is red it is in standby mode If the led is green the unit is on 5 High Level Input This input is for connecting to the amplifier s main speaker outputs 6 Low Level Input Use for low level connection Refer to previous page 7 Volume Control You are able to adjust the output level by rotating this control Clockwise increases the level If the subwoofer makes a slight distortion noise this lets you kno...

Page 4: ...h Every 2 years rotate the Woofers one screw hole OPERATION CARING FOR YOUR SUBWOOFER 1 Connect all leads making sure that all are in their correct position 2 Make sure that no music is coming from your stereo 3 Set the Volume control 7 to the 9 o clock position 4 Set the Frequency control 8 to the 12 o clock position 5 Switch the power switch 3 on 6 Play some music from your stereo amplifier and ...

Reviews: